Scroll down to «Telescope» section and click on «Setup».If device asks for a password during the connection – enter «12345678» and press «OK».Įxample of telescope configuration and management with use of SkySafari software: Then turn on your mobile device Wi-Fi mode and connect to the access point with SSID – «ServoFi». Spend a standard setting procedure recommended by the manufacturer of the telescope, namely enter into the remote location coordinates of observation, the current time and make alignment the telescope at the stars. Connect ServoFi WiFi adapter to RS-232 serial port and to the 5 – 15 V power supply source (before turning on the power of the telescope).The WiFi module works as an access point and can be used to connect all your astro devices to a single network!Īlso, the WiFi adapter can operate in local station mode. Important: ServoFi requires an external power supply of 5 – 15 V! It is possible to supply from the telescope power supply through the power splitter. HW Virtual Serial Port software creates a TCP-COM bridge allow Windows based astronomical aplications comunicate throught WIFi moduls. To use the adapter on a PC, you must create a TCP-COM port bridge. The WiFi module settings are made from the WEB interface. Also works with the SkySafari, Orion StarSeek 4 4.4.4 application for mobile devices. It can be used for a rapid telescope targeting with help of mobile devices such as smartphones or tablets. ![]() This WiFi adapter provides full wireless control of the telescope mount from a laptop or PC. ServoFi is a wireless adapter for telescope control systems on which the ServoCAT control system installed.
0 Comments
Leave a Reply. |